Gregoire Besson SP9 COMPACT, Инструкция по эксплуатации и техническому обслуживанию

Страница: 42 / 108

Operation manual SP 9 - Compact
CHAPTER IV – THE PREPARATION OF THE TRACTOR PULLING – Page 2
Rear tyres minimum distance is 140 cm, but there is danger that the tractor may jerk on the black
land in the case of plough with big number of plough bottoms.
Distance between rear tyres is maximum: 180 cm (= 70’’).
Recommended adjusting of the tyres (distance of the inner side of rear wheels) :
Distance between
tyres
(inner side)
5 plough
bottoms
6 plough
bottoms
7 plough
bottoms
8 plough
bottoms
1 distance Front wheel
158 cm
62’’
162 cm
64’’
168 cm
66’’
172 cm
68’’
2 distance Rear wheel
148 cm
58’’
152 cm
60’’
158 cm
62’’
162 cm
64’’
On the hills for the traction stability you should apply maximum tyre distance.
4.3. ADJUSTMENT FOR THE STABILIZATTION OF THE BARS
AND ROCKERS
It is easier lubricate and unrust the stabilization screw and pins (rockers and bars)
before attaching the plough to the tractor. If it is necessary take time to dismount and
adjust these stabilizations and bars in order to perform accordingly the screws
lubrication.
The stabilization of rockers and bars must be placed so that during the plough
attachment the lifting levers side clearance should be the smallest (if it is possible ≤ 1 cm ≈ 1/2’’). In
the case of the GRÉGOIRE-BESSON Compact plough we speak about semi-mounted plough so
having the 110° vertical tractive cardan axle the plough if it is necessary can turn left and right. It is
not reasonable to (even damaging) to uphold the lateral clearance of the tractor.
If between the stabilization block and lifting levers there is a very big clearance it
restrains the precise adjustment of the first furrow width and during maneuvering and
transporting the plough and tractor lifting levers can be seriously damaged.
If despite the properly mounted stabilizations the lifting levers have big clearance you should get
sleeves to avoid to prevent the levers lateral sliding on the pulling spindle. Control if the spindle and
the type of the drawbar compatible (category and Ø).