Gregoire Besson SP9 COMPACT, Инструкция по эксплуатации и техническому обслуживанию

Страница: 104 / 108

Operation manual SP 9 - Compact
CHAPTER XII - POSSIBLE SOLUTIONS OF EMERGING PROBLEMS –- Page
4
12.10. The plough depth is not the same on both sides:
The plough is not horizontal.
The tractor lifting arms are not of the same length. Check the length and blocking of two lifting arms axles.
See chapter 4: «The tractor preparation for pulling».
Three points of the plough depth adjusting are not in
the correct position (the tractor lifting device height,
the mail axle of the central bearing, the depth
adjusting wheel). Check three points of depth adjusting.
The adjustment must be equal on the right and left
sides.
See chapter 9: «Adjusting on the field».
The tractor or plough tyres height is not the same on
both sides. Check the pressure in the tyres.
The tractor or plough tyres have been worn
differently on both sides. Change and mount the wheels of the same
Ø
, which
have the same technical parameters and the same
brand.
The plough is not horizontal
Inclination angle is not suitable. Adjust the boots of inclination angle.
See chapter 9: «Adjusting on the field – second
course».
The plough bottom are not cleaned properly (new or
rusted ones).
The soil adheres to the breasts Clear away the paint, scrape the rust and ground from
the breasts.
See chapter 7: «The plough preparation before the
work». See chapter 10: «Lubrication and maintenance».
On the tractor there is only one stabilization lever (or
two levers are not the same).
The equipment affects the adjusting control reaction Check stabilization lever or the adjusting of the
controlling system.
Mount another stabilization which is the same as on the
other side.
See chapter 4 : «Tractor preparation for pulling».
The adjusting controlling sensors do not work on the
tractor.. Measure the length of the lifting levers during ploughing
to the right then to the left (or the length of the chrome-
plated bars).
If there is difference between the left and right
ploughing it is because of the wrong lifting device.
12.11. The ground adheres to the breasts:
The breasts have not been properly cleaned and
scraped. Clear away the paint, scrape the rust and soil from the
breasts..
One day work without chisel end on very adhesive soil.
Be sure that the plough sole fasteners are in good
condition (they affect the soil slipping from the breasts).
See chapter 7: «Preparation of the plough before
ploughing». See chapter 10: «Lubrication and
maintenance».
The plough bottoms do not suit the using conditions. Use plastic breasts on very adhesive soil.
From the GREGOIRE-BESSON types chose the
suitable breast or plough bottom model.
12.12. The soil is not turned properly and falls back in to the furrow:
The rear part of the breast is too high.
The edge of the breast so not leads the soil properly. Adjust two bolts of the inclination angle boots. If it is
necessary put it on the surface of the ploughing
(especially while you plough on slopes)
See chapter 9: «Adjusting on fields».
The cutting width is too big for working depth. Reduce the working width.
Increase the plough depth.
The edge of the breast do not throw the soil
properly. Mount the breast lengthening pieces.
The plough bottom should be changed soon.
The rear part of the breast is too high.
The pic adjusting is too strong and the ground goes
under the breast. The edge of the breast does not
lead the ground properly. Adjust two bolts of the inclination angle. If it is
necessary put it on the ploughing (especially if you
plough on slopes)
See chapter 9: «Adjusting on the field – second
course».