Gregoire Besson SP9 COMPACT, Инструкция по эксплуатации и техническому обслуживанию

Страница: 82 / 108

Operation manual SP 9 - Compact
CHAPTER IX – FIELD SETTINGS – Page 14
9.6.8. ADJUSTMENT OF THE PENETRATION ANGEL OF THE PLOUGH
BOTTOM (Entering)
The penetration angel is industrially set to produce the 15 mm difference between the front part of the
plough-sole the rear part which fixes the plough-sole.
Under the normal condition it is not needed but there is possibility to adjust the penetration angel of
the plough bottom (drought, extremely hard, or under special conditions).
For the greater penetrating of the plough, the plough cane (39) relating to the connecting rod should
be turned forward (40).
The turning is performed around the bottom fixing bolt (41) it is mounted into the hole of two upper
bolts (42) . The angel regulation is provided by adjusting lever (44) with fastening of two female
screws (43).
The method to be followed (Operational mode):
1. Turn the plough vertically on the needed side without putting the plough bottoms on the
ground.
2. Clear away the ground and clean the points of admittance to the bolts and control levers.
3. Dismount fastener of the plough sole (45) to be able to reach the bolt (41),
4. Loosen the fastening bolts and transporting bolts (41 and 42) in order two bolts (42) were able
to go into the long opening.
5. Loosen the front female screw of the pick control lever (43).
6. In order the plough bottom could penetrate better the rear female screw of the pick control
lever (43) should be fastened.
7. To abate the plough bottom penetration the front female screw of the p pick control lever (43)
should be loosened.
8. If all adjustment has been finished, all bolts and screws must be fastened and the fastener of
the plough sole (45) must be mounted back..