Grandstream Networks UCM6510, Руководство пользователя

Страница: 192 / 483

P a g e | 191
UCM6510 IP PBX User Manual
Version 1.0.20.31
Play Local RBT
Configure whether to play the ringback tone from local UCM6510 or not. If
enabled, the local UCM6510 will play ringback tone to the caller. Otherwise,
the caller will listen to the tone from peer device. Default setting is disabled.
Advanced Settings
Switch Type
Select switch type.

EuroISDN: EuroISDN (common in Europe)

NI2: National ISDN type 2 (common in the US)

DMS100: Nortel DMS100

4ESS: AT&T 4ESS

5ESS: Lucent 5ESS

NI1: old national ISDN type 1

Q.SIG
Coding
Select “HDB3” or “AMI”.
CRC Select whether to use CRC4 or not.
PRI Dial Plan
This setting is used to specify the type of the callee number. The service
provider
will usually verify this. The default setting is “unknown”. In some
very unusual circumstances, you may need set to “Dynamic” or
“Redundant”.
Note:
When one type is selected, you might not be able to dial another playlist of
numbers. For example, if “National” is configured, you will not be able to
dial local or international numbers.
PRI Local Dial Plan
This setting is used to specify the type of the caller number. The service
provider will usually verify this.
D-Chan Indicates the D channel for control.
International Prefix
National Prefix
Local Prefix
Private Prefix
Unknown Prefix
Configure the prefix in PRI Local Dial Plan and PRI Dial Plan for each type.
PRI T310 Configure PRI T310 Timer (in seconds). The default value is 10 seconds.
PRI Indication
Select the PRI Indication.

outofband : Use RELEASE, DISCONNECT or other messages with
CAUSE to indicate call progress (e.g., cause: unassigned number or
user busy).

inband : use in-band tones to play busy or congestion signal to the other
side. This is the default setting.
Reset Interval The interval that restarts idle channels.
PRI Exclusive This setting is used to set up the ChannelID in SETUP message. If enabled,