Gilson PLC 2050, Руководство пользователя

Страница: 44 / 132

44 inStaLLation | PLC 2050/2250/2500 PurifiCation SyStemS
IN
S
ta
LL
t
h
e St
y
LU
S
Install the Stylus
use the stylus to control the integrated software on
the touchscreen PC. a fixed holder is provided for the
stylus and its extendable cord. the stylus holder is
installed with the supplied screw on the right side of the
PLC Purification System through the threaded hole.
Make the Power Connection
the PLC Purification System is supplied with the appropriate fuses and is ready to operate
at the line voltage of the destination country. a voltage selector located near the power
receptacle allows users to adjust the input voltage of the system. Check that the position of
the voltage selector corresponds to the voltage of the mains.
to make the power connection, plug in the aC power cord into the power receptacle located
on the right side of the instrument. then make the connection between the system and the
aC power source.
● 110-120 / 220-240 V~, 50/60 Hz, 450 W (maximum)
● General fuses: t 6.3a H 250 V~ (qty. 2)
NOTE
| indicates that the electrical power is switched on; O indicates that the electrical power is
switched off.
Figure 36
Stylus and Holder
Set
Screw
Stylus
Figure 37
Power Switch and Voltage Selector
Power
Switch
fuse Drawer
Power receptacle
Voltage
Selector