Geister ESU-X 500 TT, Руководство пользователя

Страница: 21 / 45

Dateiname mit Revisionsstand: erstellt am: erstellt von: geprüft von: freigegeben von: Seite
ESU-X 500TT_EN B 01.06.15 cgro cg cgro 21 von 45
The memory number stops blinking (See the following paragraph):

When users, during the first setting of a memory, memorize the settings.

When users, during use, either cancel or memorize the changes of setting.
CANCELLATION OR MEMORIZATION OF THE CHANGES OF SETTING
Whenever users like, they can both change settings and cancel or memorize the changes. To memorize a new
setting or to memorize the change of a setting, do the following:

Push the 4 key (It is the quickest way while setting a new memory). or

Push either the 2 area or any of two 3 keys - The M screen appears.

Push the SI/YES key. M Screen - The M screen switches OFF and the number stops blinking.
To cancel a change, do the following:

Push either the 2 area or any of two 3 keys - The M screen appears.

Push the NO/NOT key - The M screen switches OFF and the number stops blinking.
By pushing the exit key, users can, in case of mistakes of use, cancel the M screen.
FIRST SETTING
Starting
Switch the unit ON and, when the self
‐
check ends, push the standby key.
Selection of a memory
Users can select the memory both by scrolling all memories and by setting a specific one. To do it, see the
paragraph SELECTION OF A MEMORY on the previous page.
Setting of the general modes of use
By the menu key of the touch screen select the related screen and set, as it is detailed in the paragraph
GENERAL MENU the following:

The socket for the cable of the neutral electrode (With european plug or “Valleylab” connector).

The mode to use the main foot ‐ switch (Not needed when using the 34-9333 or the 34-9332 foot ‐ switch).

The sockets (1 or 2) to connect and use the bipolar accessories.

The level of the acoustic signals of activation.

The colour (red or green) of the numbers /symbols of the touch screen.

The starting delay of the AUTO SOFT MICRO BICOAG, AUTO SEALING bipolar currents.
At the end of this setting, push the exit
key to go back to the main screen.
Setting of the monopolar and bipolar currents
Remember that, when users start setting a memory, the memory number blinks. See the paragraph BLINKING
OF A MEMORY NUMBER.

Push the S key of every section to set the related currents.

When pushing the related keys, the following screens are visible.