5. Control Input / Output
5-19
5-9-5 Torque ratio 1 setting
(1) Torque ratio 1 setting selection
The torque setting from ASR or from the outside can be operated with the multiplier factor given by
function “Torque ratio 1”. This function can be set from either the Operation Panel or from the serial
communication function.
Setting
input point
Setting data
Explanation
Serial
Torque ratio 1 setting
This is a setting value allowed from the host computer with
serial transmission.
Panel
Panel torque ratio 1
setting
This is a setting value allowed from the parameter (B13-1).
(2) Torque ratio 1 setting selection sequence
The interlock sequence for the Torque ratio 1 setting is shown below.
Torq ue ra tio1
settin g
S e ria l, To rq ue ra tio 1
settin g
1.00 0
O . P an el, Torqu e ratio 1
settin g (B 13 -1 )
o n
o n
o ff
o ff
M o u n te d
N o t m o u nte d
O ptio n
C FS
L C L
=1
=2
=3
C 0 2-3
:
:
X X X
X X X
Fu nction s that can b e co ntrolled O N / OFF
from term inal board
Fu nction s that can b e co ntrolled O N / OFF
By param eter setting only
Fig. 5-14 Torque ratio 1 setting selection
