GE PanaFlow HT, Руководство пользователя

Страница: 73 / 163

PanaFlow HT User’s Manual 63
Chapter 3. Initial Setup and Programming
3.7.3c Setting the Frequency (cont.)
To change the current test frequency, press
[

]
. Set a Hz value. The meter will set
the digital output to this value. Then verify at your measurement system that you
see the frequency you entered. You can repeat this procedure with several
frequencies.
To check the current error handling status, on the
Frequency
display select
Err
Handling
and press
[

]
. A screen similar to the following appears.
To change the current error handling status, select the option desired and press
[

].
The screen returns to the previous display.You have four options for error
handling in case of a measurement error:
•
Hold — hold last good value.
•
Low —show 0 Hz.
•
High — show Full Frequency.
Note:
If
Other
is selected, a screen similar to the following appears.
Enter the Hz value you want to appear for error. (For example, if Full = 1 kHz,
you may want to set
Error
to 2 kHz.) Press
[

]
again, and a screen similar to the
following appears.
Use the [

] or [

] arrow key to change the
Other
value and press
[

]
to save the
number. Press [

]
to return to the previous screen.
0
Hz