GE F60 UR Series, Инструкция по эксплуатации

Страница: 294 / 558

5-168 F60 Feeder Protection System GE Multilin
5.6 CONTROL ELEMENTS 5 SETTINGS
5
• FREQ RATE 1 MIN FREQUENCY: This setting defines minimum frequency level required for operation of the element.
The setting may be used to effectively block the feature based on frequency. For example, if the intent is to monitor an
increasing trend but only if the frequency is already above certain level, this setting should be set to the required fre-
quency level.
• FREQ RATE 1 MAX FREQUENCY: This setting defines maximum frequency level required for operation of the ele-
ment. The setting may be used to effectively block the feature based on frequency. For example, if the intent is to mon-
itor a decreasing trend but only if the frequency is already below certain level (such as for load shedding), this setting
should be set to the required frequency level.
Figure 5–88: FREQUENCY RATE OF CHANGE SCHEME LOGIC
| V _ 1 | > P I CKUP
F R EQ RAT E 1 BLOCK:
Off
RU N
F R EQ RAT E 1 SOURC E :
Pos seq vo l tage (V _ 1)
F R EQ RAT E 1 F U N CT I O N :
S ETT IN G S
E nab l ed = 1
Pos seq current ( I_ 1)
F requency ( F )
A
N
D
F R EQ RAT E 1 OV SUPV
P I CKUP:
S ETT IN G
S ETT IN G
| I_ 1 | > P I CKUP
RU N
F R EQ RAT E 1 OC SUPV
P I CKUP:
S ETT IN G
F > M IN & F < MAX
RU N
F R EQ RAT E 1 M IN
F R EQ U EN CY:
S ETT IN G S
F R EQ RAT E 1 MAX
F R EQ U EN CY:
A
N
D
Ca l cu l ate df/dt
RU N
df/dt > P I CKUP
RU N
S ETT IN G S
F R EQ RAT E 1 P I CKUP:
F R EQ RAT E 1 TR EN D:
FLEXLOG I C OPE R A N D S
F R EQ RAT E 1 DPO
F R EQ RAT E 1 OP
F R EQ RAT E 1 PKP
F R EQ RAT E 1 R E S E T
D E LAY:
S ETT IN G S
F R EQ RAT E 1 P I CKUP
D E LAY:
t
PKP
t
RST
832023A2.CDR