Fujitsu M10 Series, Руководство по установке

Страница: 278 / 374

XSCF> testsb -v -p -s -a -y
Initial diagnosis is about to start, Continue?[y|n] :y
SB power on sequence started.
POST Sequence 01 Banner
Note -
A cable check with the diagxbu command is not necessary because this command
with the -a option specified performs a diagnosis test on all the mounted system boards
(PSBs).
XSCF>
showlogs error
-s: Executes the "show-devs" command of OpenBoot PROM and displays the
results while a diagnosis is being processed
-a: Diagnoses all the mounted PSBs
-y: Automatically responds with "y" to a query
If an error is displayed, see " A.2.4 Checking diagnosis results ."
16.
Execute the showlogs error command, and confirm that no error is displayed.
If an error is displayed, see " A.2.2 Checking the contents of logs ."
17.
Execute the showhardconf command from the master XSCF to check the
configuration, status, and quantities.
For details, see " 6.8 Checking the Component Status ."
18.
If the installation expanded the 1BB configuration to a multiple-BB configuration,
configure the XSCF network.
For details, see " 7.5.2 Setting an Ethernet (XSCF-LAN) IP address " and " 7.5.3
Setting a takeover IP address ."
After configuration, execute the applynetwork command to apply the settings,
and confirm that they were reflected. Then, execute the rebootxscf command to
complete settings, and go to the next step. For details on the procedure, see
" 7.5.6 Applying network settings ."
19.
To configure memory mirroring for the installed SPARC M10-4S, set memory
mirror mode.
For details, see " 7.6 Configuring Memory Mirroring ."
20.
Create physical partition configuration information.
For details, see " 7.7 Creating a Physical Partition Configuration List (PCL) ."
21.
Add the system board (PSB) to the physical partition.
For details, see " 7.8 Assigning a System Board (PSB) to a Physical Partition
(PPAR) ."
22.
Check the CPU Activation key information, and assign CPU resources to the
physical partition.
For details, see " 7.11 Registering a CPU Activation Key ."
23.
Execute the poweron command to start the system.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015 264