Fujitsu M10 Series, Руководство по установке

Страница: 324 / 374

| XSCFIFU | 0 |
| PSU | 0 |
| FANU | 0 |
+-----------------------------------+------------+
XSCF> showlogs error
Date: Oct 29 16:35:09 JST 2012
Code: 80000000-003bff0000ff0000ff-01a100040000000000000000
Status: Alarm Occurred: Oct 29 16:35:01.895 JST 2012
FRU : /BB#1
Msg: BB control cable detected unexpected
XSCF> showlogs error
Date: Nov 08 11:01:37 JST 2012
Code: 10000008-007cff0000ff0000ff-019204310000000000000000
Status: Information Occurred: Nov 08 11:01:32.813 JST 2012
FRU : /BB#1/XBU#0/CBL#0R
A.2.2 Checking the contents of logs
Use the showlogs command to check error logs.
showlogs command
The showlogs command is a command that displays the specified log. By default, the
command displays the log in chronological order from the oldest time stamp. You
can specify the following logs.
On individual systems, specify the type of log to display from the collected logs. You
can specify one of the following:
■
error:
Error log
■
power:
Power log
■
event:
Event log
■
monitor:
Monitoring message log
On individual chassis of the SPARC M10 systems, specify the type of log to display
from the collected logs.
■
env:
Temperature history
On individual physical partitions (PPARs), specify the type of log to display from the
collected logs. You can specify one of the following:
■
console:
Console message log
■
panic:
Panic message log
■
ipl:
IPL message log
Example: Display example where an XSCF cable is incorrectly connected
Example: Display example where crossbar cables are incorrectly connected as shown
in Figure A-1
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015 310