Fujitsu M10 Series, Руководство по установке

Страница: 200 / 374

XSCF>
rebootxscf -y -a
The XSCF will be reset. Continue? [y|n] :y
Note -
If -a is specified, the command reboots the XSCF of every SPARC M10-4S and crossbar
box. If you want to reset a specific SPARC M10-4S, specify -b bb_id.
XSCF> showtimezone -c tz
UTC
XSCF>
settimezone -c settz -a
Africa/Abidjan
Africa/Accra
Africa/Addis_Ababa
Africa/Algiers
Africa/Asmara
Africa/Asmera
Africa/Bamako
Africa/Bangui
.
changing the setting values described in " 6.6 Checking the Time Setting ,"
you can skip step 3 and subsequent steps because the XSCF is reset in that
procedure too.
Executing the rebootxscf command disconnects the XSCF session.
The following example resets all the XSCFs and automatically selects "y" for the
confirmation message.
4.
Log in to the XSCF again
.
For details, see " 6.3 Logging In to the XSCF ."
6.6 Checking the Time Setting
This section describes the procedure for setting the system date and time.
The date and time in the factory default settings are set in coordinated universal time
(UTC). If you want to display the time in the local time (JST), first set the time zone
and then check the time. Change the setting as needed.
1.
Execute the showtimezone command to check the time zone.
The following example displays the factory default setting (UTC).
2.
To set the time zone, execute the settimezone command, and check which
time zones can be set.
If you do not want to set the time zone, skip steps 2 and 3.
The following example displays a partial list of time zones that can be set.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015 186