Fuji Xerox DocuPrint CM505 da, Руководство администратора

Страница: 549 / 599

HP-GL2 Emulation
549
Ap
pe
ndix
14
paper (75 plotter units) to the active coordinates area obtained in step 1.
The active coordinates area obtained in step 2 is
-8474,-6013,8474,6013 .
3) The value set in paper margins (10 mm = 400 plotter units) is subtracted from the
active coordinates area obtained in step 2.
The active coordinates area obtained in step 3 is
-8074,-5613,80740,5613 .
4) As the active coordinates area obtained in step 3 exceeds the A4 size and is A3
size, the document size is determined to be A3.
In addition, when the paper margin setting is 0 mm and the active coordinates area
is
8474,-6013,8474,6013 , and this exceeds A3, but is A2 or smaller, the document size
is determined to be A2.
How to Determine Paper Size
If the operation panel settings are as follows, the paper size is determined as below.
Document size: Auto
Paper Tray: Auto
The method for determining the paper size differs according to the paper size and
scaling mode settings on the operation panel.
„ If the Paper Size Setting is A Sizes
The paper size between the two sizes (A4 and A5) that is actually loaded in the trays
become the possible paper size.
If A series paper (A4 and A5) is not loaded in the trays, all two sizes, A4 and A5 become
possible sizes; a message is displayed on the touch screen prompting the user to load
A series paper.
„ If the Paper Size Setting is Auto
The paper sizes three sizes (A4, B5, and A5) that are actually loaded in the trays
become the possible paper size.
If A4, B5, or A5 paper is not loaded in the trays, all five sizes become possible sizes; a
message is displayed on the touch screen prompting the user to load paper.
„ If the Scaling Mode Setting is Paper Size
If the paper size and the document size are the same, select paper that is the same
size as the document.
If the document size is larger than any possible paper sizes, select the largest paper.
If the document size is smaller than any possible paper sizes, select the smallest paper.
„ If the Scaling Mode Setting is ACA
Select the smallest paper size that can contain the ACA.
If the active coordinates area is larger than any possible paper sizes, select the largest
paper.
If the active coordinates area is smaller than any possible paper sizes, select the
smallest paper.
Note • If the document size is set to anything other than Auto, the paper size is the one set on the
control panel.
• If the paper tray is set to Auto, the paper size is the one loaded in each tray. However, If
paper whose size is not supported is loaded, an error message will be displayed prompting
the user to load a supported paper.