Fronius Symo GEN24 3.0, Руководство по эксплуатации, Страница: 81 / 144

Backup power nominal voltage
When backup power mode is activated, the nominal voltage of the public grid must be
selected.
State of charge warning limit
A warning is output when the residual capacity of the battery specified here is reached in
backup power mode.
Reserve capacity
The set value results in a residual capacity (depending on the capacity of the battery)
that is reserved for backup power. The battery is not discharged below the residual capa-
city in grid-connected operation.
Load management
Up to four pins can be selected for load management here. Additional load management
settings are available in the "Load management" menu item.
Default: Pin 1
Australia - Demand Response Mode (DRM)
The pins for control via DRM can be set here:
Mode Description Information DRM pin I/O pin
DRM0 Inverter disconnects it-
self from the grid DRM0 occurs if there is an
interruption or short circuit
on the REF GEN or COM
LOAD leads, or if the com-
binations DRM1 - DRM8
are invalid.
The mains relays open. REF GEN
COM
LOAD
IO4
IO5
DRM1 Import P
nom
≤ 0%
without disconnection
from the grid
currently not supported DRM 1/5 IN6
DRM2 Import P
nom
≤ 50% currently not supported DRM 2/6 IN7
DRM3 Import P
nom
≤ 75% &
+Q
rel
* ≥ 0%
currently not supported DRM 3/7 IN8
DRM4 Import P
nom
≤ 100% currently not supported DRM 4/8 IN9
DRM5 Export P
nom
≤ 0%
without disconnection
from the grid
currently not supported DRM 1/5 IN6
DRM6 Export P
nom
≤ 50% currently not supported DRM 2/6 IN7
DRM7 Export P
nom
≤ 75% &
-Q
rel
* ≥ 0%
currently not supported DRM 3/7 IN8
DRM8 Export P
nom
≤ 100% currently not supported DRM 4/8 IN9
The percentages always refer to the nominal device output.
IMPORTANT!
If the Demand Response Mode (DRM) function is enabled and no DRM control is con-
nected, the inverter switches to Standby mode.
Demand Re-
sponse Modes
(DRM) Here you can enter a value for the apparent power input and the apparent power output
for the Australia country setup.
81
EN