Fronius Symo GEN24 3.0, Руководство по эксплуатации, Страница: 120 / 144

1
Switch off power to the inverter and wait
for the specified time (2 minutes) until the
capacitors have discharged and the fan
has shut down.
Turn the DC disconnector to the "Off"
switch position.
2
Loosen the screws on the underside of the
housing cover by rotating them 180° to the
left using a screwdriver (TX20). Then lift
the housing cover away from the inverter
at the bottom and detach from above.
3
Remove any build-up of dirt on the heat
sink and fan using compressed air, a cloth,
or a brush.
NOTE!
Risk due to damage to the fan bearing
from improper cleaning.
Excessive speed and pressure on the fan
bearing can cause damage.
▶
Block the fan and clean it with com-
pressed air.
▶
When using a cloth or brush, clean
the fan without applying pressure to
the fan.
To start up the inverter again, follow the steps listed above in reverse order.
Disposal Waste electrical and electronic equipment must be collected separately and recycled in
an environmentally responsible manner in accordance with the European Directive and
national law. Used equipment must be returned to the distributor or through a local, au-
thorised collection and disposal system. Proper disposal of the old device promotes sus-
tainable recycling of material resources. Ignoring this may lead to potential health/envir-
onmental impacts.
120