Fresa G024, Руководство по обслуживанию

Страница: 158 / 178

31 March, 1999 PAPER FEED SECTION
6-45
Replacement
Adjustment
6.6.5 PCU HOLDER
ø
CAUTION
Before removing the torsion springs [B] in the following procedure, make
sure that the front cover is closed (to release pressure).
If the springs are removed while pressure is applied to them, they may
jump out and cause injury.
1. Remove the sensor bracket [A] (two
screws, two connectors).
2. Remove the bracket [B] (two
screws). Remove the right and left
torsion springs {C]. Remove the
right and left caps [D] (one screw
each).
3. Open the paper feed frame and unplug
the ID sensor connector. Pull out the
right and left rotation shafts [F] until
the PCU holder [E] can be removed.
NOTE: Do not entirely pull out the
rotation shafts, or the paper
feed frame will drop. Hold the
PCU holder with one hand,
and gradually pull out the
rotation shafts with the other
hand. To remove the PCU
holder, lift it with the front side
panel kept vertical.
When installing the PCU
holder, keep the front side
panel vertical and lower it straight down between the printer side
panels. (There is a toothed section [G] below the left side panel of the
holder, which engages the damper gear [H].)
G024R409.WMF
G024R410.WMF
[A]
[C]
[B]
[D]
[E]
[F]
[G]
[H]