Fresa G024, Руководство по обслуживанию

Страница: 116 / 178

31 March, 1999 EXTERIOR
6-3
Replacement
Adjustment
6.1.3 BOTTOM FRONT COVER
1. Open the front cover half way, and remove two snap rings [A].
2. Carefully slide the hinge levers [B] out from the bottom front cover [C].
NOTE: The levers are spring loaded.
3. Remove the bottom front cover.
6.1.4 FRONT COVER AND OPERATION PANEL
1. Open the by-pass tray [A].
2. Remove two screws [B] and carefully lift the front cover [C] from the printer.
3. Remove the operation panel [D] from the front cover (two hooks). Make sure to
unplug the connector from the operation panel.
NOTE: The surface of the operation panel circuit board is not insulated. If turning
on the printer while the operation panel is removed from the front cover, be
careful not to short-circuit this board.
G024R268.WMF
G024R153.WMF
[A]
[A]
[B]
[B]
[C]
[B]
[C]
[D]
[B]