Fresa G024, Руководство по обслуживанию

Страница: 109 / 178

ENGINE SP MODE 31 March, 1999
4-12
4.2.12 IMAGE ADJUST
Use this menu to adjust the reproduction ratio of images.
With the top left corner as the reference point, adjustment can be done in steps of
0.1% within
±
1%.
Layer 1 Layer 2 Layer 3 Layer 4
Image Adjust
Main Scanning Main Scanning
XXX
Maintenance
10:Image adjust Image Adjust
Sub-scanning Sub-scanning
XXX
4.2.13 OUTPUT CHECK
Use this menu to check the operation of the clutches, motors, and solenoids
individually.
NOTE: Before testing the PCU, main, or revolver motors, remove the load
beforehand (to do this, remove the motor from the machine, but keep it
connected).
The table below shows the Output Check menu details.
Layer 1 Layer 2 Layer 3 Layer 4
Maintenance
11:Output Check Out Put Check
XXXXXXXX XXXXXXXX
ON (OFF)
Name Display Operation
By-pass feed clutch Bypass Feed Cl. Operating for a certain
time
Pull-out clutch Pick-up Cl. Operating until inputting
OFF
Paper feed clutch Feed Cl. Operating for a certain
time
Relay roller clutch Transport Cl. Operating until inputting
OFF
Registration clutch Regist. Cl. Operating until inputting
OFF
Transfer roller clutch Tr. Roller Cl. Operating for a certain
time
Development drive solenoid Development Sol. Operating until inputting
OFF
By-pass feed solenoid Bypass Sol. Operating for a certain
time
Transfer belt cleaning solenoid Cleaning Sol. Operating until inputting
OFF