40
-
Flex 1-9 for reading customer specific codes (only if flex dongle is installed)
•
Read from feeder: press the
button to select a feeder to activate OMR on.
•
Reverse reading: reverse reading means that the insert mark is on the first page of
the set. The system will detect the end of a set by detecting the first page of the next
set. Because of the feeding and collating principal reverse reading has the following
limitations:
-
The last mark of the code should be printed maximally 85 mm (3.3 inch) from the
top.
-
Enclosures and selective enclosures cannot be handled. When a Thin Booklet Feeder
module is added to the system configuration, enclosures and selective enclosures
can be handled with reverse reading.
When reverse reading is used, the reverse reading symbol (
) is shown in the
“job info” screen.
In case the feeder runs empty, the last set is still on the collator because the
beginning of the next set could not be detected. In this case the feeder empty
message contains an
function. By pressing the
button the set on the
collator will be inserted.
Note
Reverse reading is not available in OMR level 0, 1, 2 and 3.
By pressing the
button the next “OMR settings”
menu appears. This menu covers the following
settings:
•
1st mark from top: press
to set the
position of the first optical mark, measured from
top of the sheet. The value can be varied
between 15 mm (0.6 inch) and 277 mm
(10.9 inch).
•
Max. sheets: select the maximum amount of
sheets in the set of documents using the arrow buttons.
Содержание 6602 Series
Страница 1: ...6602 Series Inserters OPERATOR MANUAL FIRST EDITION 8 2007...
Страница 6: ...5 ENGLISH Conventions Note A note gives additional relevant information...
Страница 7: ...6...
