30
Insert Position
Note
This adjustment must only be checked in case of problems or when changing the envelope
type.
1. Lift the unlocking lever of the upper unit and pull
up the upper unit.
The flap folding line must be positioned under
the green indicator B. If not, adjust the insert
position as follows:
2. Press on the left or right side of
to
adjust the insert position to the left or the right.
Each button stroke stops the next envelope
0.5 mm (0.02 inch) to the right (earlier) or to
the left (later).
3. Press
to load a new envelope
into the insert position.
4. Recheck the insert position, and adjust as required.
If necessary adjust the envelope insert fingers, see ”Adjust the Envelope Insert
Fingers” on page 30.
Adjust the Envelope Insert Fingers
To adjust the envelope insert fingers:
1. Loosen the knurled knob C on top of each finger.
2. Adjust each finger so that the tip enters about 5 mm (0.2 inch) into the envelope.
3. Re-tighten the knurled knob.
The fingers can be moved sideways to the desired position.
4. Place the outer fingers about 5 to 10 mm (0.2 to 0.4 inch) from the edges of the
envelope.
Check the position of the insert fingers when changing to a different type of envelope.
Address Position
When the envelope position and the position of the fingers is correct:
1. Press
to load a folded sheet into the envelope.
The envelope will not be sealed and ejected to the present on deck location.
2. Check the position of the address in relation to the address window in the envelope.
3. If necessary, press the Up or Down button to adjust the address position.
Each key stroke brings the address 1 mm (0.04 inch) with a maximum of 12 mm
(0.48 inch) lower or higher.
A
B
C
D
Содержание 6602 Series
Страница 1: ...6602 Series Inserters OPERATOR MANUAL FIRST EDITION 8 2007...
Страница 6: ...5 ENGLISH Conventions Note A note gives additional relevant information...
Страница 7: ...6...
