Formax 6602 Series, Руководство оператора

Страница: 29 / 93

28
2. Turn knob A clockwise until one envelope will pass between the rollers. The bottom
envelope must enter the separator first.
Now the envelope separation is set.
After starting the system it may occur that more than one envelope at a time is pulled in.
In that case rotate knob A a quarter turn clockwise. Repeat if necessary to obtain correct
operation.
3.5.4 Feeding Envelopes
1. Place the bottom envelope between the rollers (flap down and trailing - bottom side of
envelope pointing to the machine).
2. Loosen the stack of envelopes and place the stack on top of the bottom envelope.
3.6 Sealing Envelopes
Note
Refer to 5.1 ”Operator Maintenance” on page 72 as well.
When the sealing of the envelopes is enabled, the
sealing liquid reservoir must be filled.
1. Open the front cover B.
2. Fill the reservoir A to the “Max” level indication
with sealing liquid.
3. Close the front cover B.
Before starting the job, wait approximately 5
minutes for the brushes to moisten.
3.7 Job Selection or AutoSet
When you are ready with the preparations
(paragraph 3.2 to 3.6) continue using the AutoSet
function (see 3.7.1 ”Using AutoSet” on page 28)
or select another job and perform a test run
(3.7.2 ”Select Another Job” on page 31).
The AutoSet feature determines automatically its
job settings by measuring the sizes of documents and envelope. From all feeders that are
loaded one sheet will be taken. Based on the maximum document length (which is also
the length of the document-set) and the length of the envelope the fold type is
determined.
3.7.1 Using AutoStart
When AutoSet is started, the machine will pick one sheet from each filled feeder. The
picked documents will be folded (if necessary) and inserted into an envelope.
Only the feeders that feed successfully will be selected. In the AutoSet job only the
Double Feed Control (DFC) of the upper feeder will be selected (automatically).