51
ENGLISH
Minimum Code / Basic Commands
The minimum code is one mark in one line (insert).
However for reliability it is advised to use at least 2
marks.
The first line is the start mark (1-track OMR only).
A mark printed on the second line means insert. No
mark on the second line means accumulate.
Note
In some cases, on request of the customer, the reading of the basic commands can be
reversed by the service organization. This means that no mark is interpreted as an insert
command and that for the accumulate command a mark has to be printed.
Code Position and Free Area
•
The code must be printed minimally 15 mm (0.59 inch) away from top and 20 mm
(0.79 inch) from the bottom of the sheet.
•
Default the first mark from the top is set to 100 mm (3.9 inch).
•
From the left hand and right hand side 7 mm (0.28 inch) must be kept clear.
•
The code must appear in the same location and have a consistent number of marks on
every page.
•
For each additional mark one additional line is necessary.
Length
Above the first mark and below the last mark a space
of 8.5 mm (0.33") must be kept without printing.
This means that the minimum code area consists of 6
lines:
•
2 lines to print the (basic) commands
•
4 lines free space
Line distance may be 2.54 mm (0.1") to 6.35 mm
(0.4").
Code Width, Character Spacing and Pitch
The minimum width of the code area is 7 character
spaces. From left to right:
•
2 characters space not printed (4.2 mm; 0.17")
•
Track mark (3 characters or 6.3 mm; 0.24")
•
2 character spaces not printed
Pitch 10 or 12 is accepted.
The track mark can be printed using the underline sign (_), which must have a thickness
of at least 0.2 mm (0.08").
Start mark
Insert/accumulate
Line 1
Line 2
Line 3
Line 4
Line 5
Line 6
8,5 mm
8,5 mm
4,2 mm
4,2 mm
6,3 mm
Содержание 6602 Series
Страница 1: ...6602 Series Inserters OPERATOR MANUAL FIRST EDITION 8 2007...
Страница 6: ...5 ENGLISH Conventions Note A note gives additional relevant information...
Страница 7: ...6...