Fluke endurance series, Руководство пользователя

Страница: 68 / 102

Endurance® Series
Users Manual
56
The Reset signal causes a new reading of the current measured temperature and restarts the
selected signal post processing function.
7.12. Factory Defaults
To globally reset t
he unit to its factory default settings, go to the “factory default” menu item
under the configuration screen menu display. The baud rate and communications mode (single
device or multiple devices / multidrop) will not be affected.
Table 4: Factory Defaults
Parameter E1M, E2M, E3M E1R, E2R
Mode (1C / 2C) 1C 2C
Temperature Unit (°C / °F) °C °C
Slope n/a 1.000
Emissivity 1.000 1.000
Transmissivity 1.00 1.00
Average 0.0 0.0
Peak Hold 0.0 0.0
Valley Hold 0.0 0.0
SETPOINT in (°C / °F) 0.0 0.0
DEADBAND in (°C / °F) 2 2
RS485 Communication Mode 2-wire , 38.400 Baud * 2-wire, 38.400 Baud *
MULTIDROP ADDRESS 000 (single sensor) 000 (single sensor)
TERMINAL RESISTOR OFF OFF
ETHERNET DHCP OFF OFF
ETHERNET IP-ADDRESS 192.168.42.132 192.168.42.132
ETHERNET NETMASK 255.255.255.0 255.255.255.0
ETHERNET GATEWAY ADDR. 192.168.42.1 192.168.42.1
ETHERNET PORTNUMBER 6363 6363
WEB SERVER OFF OFF
ANALOG OUTPUT MODE 4
– 20mA
4
– 20mA
OUT Lo LIMIT for 4 mA
Low limit sensor temp.
(e.g. 400.0°C) Low limit sensor temp.
(e.g. 400.0°C)
OUT Hi LIMIT for 20 mA
High limit sensor temp.
(e.g.1800.0°C) High limit sensor temp.
(e.g.1800.0°C)
ANALOG INPUT MODE 4
– 20mA
4
– 20mA
IN Lo LIMIT for 4 mA
Low limit sensor temp.
(e.g. 400.0°C) Low limit sensor temp.
(e.g. 400.0°C)
IN Hi LIMIT for 20 mA
High limit sensor temp.
(e.g.1800.0°C) High limit sensor temp.
(e.g.1800.0°C)
Serial Output Transmission Mode
Burst mode,
Default string = UTSI Burst mode,
Default string = UTSI
Relay Output Control
Controlled by unit,
NO function,
indicates failsafe alarms Controlled by unit,
NO function,
indicates failsafe alarms
Set Output Current
Controlled by unit,
4-20 mA Controlled by unit,
4-20 mA
Lockout Control Panel Access Unlocked Unlocked
* RS485 Modes, like Baud Rate or 2-wire half duplex are unchanged, when the factory