9 Measurement
9.4 Display of measured values
FLUXUS G801
2020-06-26, UMFLUXUS_G801V1-0EN
102
9.4.5
Transducer distance
The transducer distance can be displayed during the measurement by scrolling with
.
The optimum transducer distance (here: 51.2 mm) will be displayed in parentheses, followed by the entered transducer
distance (here: 50.8 mm).
The optimum transducer distance might change during the measurement (e.g., due to temperature fluctuations).
A deviation from the optimum transducer distance (here: 0.4 mm) will be compensated internally.
R
flow profile
information about the flow profile based on the Reynolds number
T
fully turbulent flow profile
L
fully laminar flow profile
↕
transition range between laminar and turbulent flow
?
unknown, cannot be calculated
F
flow velocity
comparison of the measured flow velocity with the flow limits of the system
√
OK, the flow velocity is not within the critical range
↑
the flow velocity is above the current limit
↓
the flow velocity is below the current cut-off flow
0
the flow velocity is within the limit range of the measuring method
?
unknown, cannot be measured
Fig. 9.4:
Display of the transducer distance
Notice!
Never change the transducer distance during the measurement.
Tab. 9.5:
Description of the status line
value
explanation
L=(51.2) 50.8 mm
54.5
m3/h
