Flexball Italiana S.r.l.
16
4.3.2. For command stations after serial number 18500
At power-up, the command station emits a sequence of flashes that depends on the type of station (single or
double) and on the status of the DIP-SWITCH2. The possible behaviours of the command station are the
following:
1. If the station is single lever all the LEDs remain ON for 2s before moving on to the next state; if the
station is double lever, all the LEDs remain ON for 0.25s before moving on to the next state
2. If the DIP-SWITCH 2 is ON, the two central LEDs (Command and Warm-Up) are turned on for
0.25s and then the two side LEDs (Engine) stay ON for another 0.25s. Otherwise the station goes to
the next state
After step 1 and step 2 the station will perform with the normal LEDs management, based on station and
system status.
1° flash
(identifies the number of engines)
2° flash
(only if DIP switch n° 2 is ON)
Installation with 1 engine
Long (2 seconds)
Short (0,25 seconds)
Installation with 2 engines
Short (less than 0,25 second)
Short (0,25 seconds)
Note: the number of flashes corresponding to the number of actuators present in the system (as depicted in
section 4.3.1.) is no longer executed.
4.3.3. 4500 twin-engine stations: how to assign the Synchro function to the
operating lever (after serial number 18500)
By default the Synchro function is assigned to the left lever. It is possible to change or assign the Synchro
function either to the left or to the right lever, following the instructions here below:
1. activate the Synchro as usual
2. bring both levers in neutral
3. press the two push-buttons on the side of the lever that you want to use for the Synchro:
"Engine" left and "Syncro / WarmUp" for the left lever
"Command" and "Engine" right for the right lever
4. keep the push buttons pressed for at least 10s
5. if the operation is successful, the LEDs pair corresponding to the push buttons pressed will flash
The programming is then stored in the device memory. The operation must be repeated for all the control
stations of the system.
