Flexball Italiana S.r.l.
75
13.2. Sea trials
Now your programming is finished!
In order to verify the settings you need to activate your electronic control system.
Switch-of the power supply and then switch on again.
If all the settings have been done correctly, the command station will look as follow:
To learn about how to command the boat go to chapter 3 (Pilot Instructions).
You must test now the correct functioning of the gearbox and the throttle in relation to the command lever.
After having set the stroke positions, it might happen that there is not the right correspondence between the
direction of the lever and the movement executed by the actuator (e.g.: you move the lever forward and the
gearbox cable is pushing instead of pulling).
Changing the value of parameter A0 you can modify the correlation between the direction on the lever and the
direction on the actuator. The table here below defines the directions of throttle and gearbox in relation to the 4
possible values of parameter A0,
with the assumption to move the command station lever in forward
direction
(gearbox forward and engine accelerated).
Value A0
Throttle
Gearbox
1
Push
(direction UL)
Pull
(direction 0H)
2
Push
(direction UL)
Push
(direction 0L)
3
Pull
(direction UH)
Push
(direction 0L)
4
Pull
(direction UH)
Pull
(direction 0H)
Factory setting A0 = 4