Flexball Italiana S.r.l.
67
Follow the steps from 1 to 8 as reported here below:
1. Verify that the actuator’s throttle lever is at minimum position, as depicted in the picture here below (1).
The lever should be at 10 mm from the knob, otherwise enter into the jog programming mode and move
the actuator’s lever to this position. For this operation follow steps from 1 to 7 section 13.1. The minimum
speed throttle position is parameter “UL”.
2. Verify that the position of the throttle lever is in idle position on the motor side as described at section
12.2.1. The push-pull cable must show its maximum stroke on the actuator’s side. Then screw the eyelet
(h) onto the cable’s rod (2).
1
2
3. Position the push-pull cable with the hole on the eyelet (H1) aligned with the hole of the plastic slider (H2).
Insert the screw (+ elastic washer) and fasten it.
3
5 mm
H1
H2
a
