Flexball Italiana S.r.l.
84
15. Programming of actuators for mechanical engines and
electronic gearbox
15.1. Installation of engine the push-pull cable and programming of
throttle mechanical strokes
For the connection of the push-pull cables please
refer to chapter 12. To set strokes refer to 13. In
case of actuators for 2 mechanical accelerators
and 2 electronic gearboxes, the following
parameters must be programmed.
15.2. Programming of the push-pull cable strokes
With this kind of actuator you must program 2 positions for each engine (minimum throttle and maximum
throttle). For the general programming instructions please refer to chapters 12 and 13.
15.3. Electrical cabling of the gearbox
For each gearbox are available 2 output relays. For proper wiring please refer to sections 5.4.2, 5.4.3, 10.2.5
and 10.2.6. of this manual.
15.4. Specific parameters
Installations with electronic gearbox might require a delay time when you pass the lever directly from reverse
to forward or from forward to reverse. Factory setting is 0,5 seconds.
Code
display
Description
Values
Factory value
Value shown on
display (factory
value)
dI
Delay in switching off the gearbox
0 .. 9,9 s
0,0 s
00
dA
Delay in start of throttle
0 .. 9,9 s
0,0 s
00
dF
Delay in neutral; it occurs any time you
move directly from forward to reverse or
from reverse to forward. This delay does
not occur when from neutral you move to
forward or reverse.
0 .. 9,9 s
0,5 s
05
Parameters
Values on
display
Left throttle
UL
UH
Right throttle
PL
PH
UL
PL
PH
UH
Acceleratore sinistro
Left throttle
Acceleratore destro
Right throttle
S
p
in
g
e
P
u
s
h
T
ir
a
P
u
ll
S
p
in
g
e
P
u
s
h
T
ir
a
P
u
ll
