Flexball Italiana S.r.l.
79
13
Press the “Down” push button and the display will move to “1L”
(parameter of left Gearbox Reverse)
14
Press the “Enter” push button and the display will start flashing.
Press “Up” until the cable reaches the position of Gearbox Reverse
15
To store the position of Gearbox Reverse, press “Enter” again. When the
display stops flashing it means that you have stored the position
16
Press the “Down” push button and the display will move to “1F”
(parameter of Gearbox Neutral)
17
Press the “Enter” push button and the display will start flashing. Press
“Up” until the cable reaches the position of Gearbox Neutral
18
To store the position of Gearbox Neutral, press “Enter” again. When the
display stops flashing it means that you have stored the position
19
Press the “Down” push button and the display will move to “1H”
(parameter of Gearbox Forward)
20
Press the “Enter” push button and the display will start flashing.
Press “Up” until the cable reaches the position of Gearbox Forward
21
To store the position of Gearbox Forward, press “Enter” again. When the
display stops flashing it means that you have stored the position
►
Important:
•
a not precise setting of the strokes may generate malfunctioning of the gearbox (delays in clutch-in,
clutch-out) or an excessive current absorption on the actuator.
•
in case of stern drive and outboard engines, if the engine isn’t running, it isn’t possible to set the
strokes, because the clutch-in operation becomes very hard. In this is the case, actuate the rotation of
the propeller manually, this will make easier the clutch-in of the gearbox.
