Flexball Italiana S.r.l.
70
Follow the steps from 1 to 8 as reported here below:
1. Verify that the actuator’s gear lever is in neutral position, as depicted in the picture here below (1). The
lever should vertical, otherwise enter into the jog programming mode and move the actuator’s lever to
central position. For this operation follow steps from 1 to 7 of section 14.1. The neutral position is
parameter “0F”.
2. Verify that the position of the gearbox lever is in neutral on the motor side as described previously. The
push-pull cable must be at its half stroke on the actuator’s side. Then screw the eyelet (h) onto the cable’s
rod (2).
1
2
3. Position the push-pull cable with the hole on the eyelet (H1) aligned with the hole of the plastic slider (H2).
Insert the screw (+ elastic washer) and fasten it.
3
H1
H2
a