Flexball Italiana S.r.l.
90
18. Programming of actuators with electronic CANBUS engine
and electronic gearbox
18.1. CANBus engine parameters
For parameter setting, please refer to section 17.2.
18.2. Electronic gearbox parameters
For parameter setting, please refer to section 16.
18.3. Wiring of the actuator outgoing cables
For wiring of the cables outgoing from the actuator refer to section 10.2.
19. System configuration in case of options
19.1. Commissioning of actuators for installations with Trim or Flap
command option
Trim or flap options don’t require any programming on the actuator.
Trim and flap cables are reported from section 6.4 to section to 6.5 included.
Sections 5.3.2 and 5.3.3 depict the pin-out of the electronic PCBs which perform the trim/flap commands.
Electrical installation schemes are at sections 10.2.7 and 10.2.8.
19.2. Commissioning of actuators for installations with Trolling
option
Refer to separate document “Trolling_Flap option for lever 3500 & 4500”.
