TST
Assembly Instructions
FUZ2-A/-B/-C/-CX/-L
FEIG ELECTRONIC GmbH
Page 7 of 71
FUZ2-A-B-C-CX-L_Montageanleitung_GB_10.docx
2
Safety information
ATTENTION
Failure to observe the safety advisories can result in physical harm or damage to the controller.
When starting up and operating the controller, the following important safety advisories as well as the installation
and wiring notes must be strictly observed:
In accordance with the EC Machinery Directive only qualified personnel shall install the device on the doors or at
the drive units for doors or bring them together.
The respective safety requirements for the entire door (machine) must
be aligned with the possibilities to meeting these safety requirements on the controller.
Improper integration of the controller into the door complex
– e.g. missing sensors, incorrect parameters, speed set
excessively high, etc.
– presents the risk that the door is operated without adequate safety precautions.
The commissioning of this controller is prohibited until it has been properly attached to the door that conforms with
the EC Machinery Directive and for which an EC declaration of conformity according to Annex II of the Directive
was obtained.
The following information describes standard applications that may not necessarily match the actual application. The actual
application is provided by the manufacturer of the door as part of the overall documentation or as part of the
operating
instructions of the door.
Any installation, startup and maintenance work must only be performed by qualified specialists.
In particular, the
following regulations must be observed: VDE0100, EN 50110 (VDE0105), EN 60204 (VDE0113), EN 50178 (VDE0160), EN
60335 (VDE0700), fire protection codes, accident prevention regulations as well as the relevant regulations for industrial
doors and machine safety standards (EN ISO 13849, EN 62061)(ZH1/494, EN12453, EN12978)
This device is not intended for use by persons (including children) with limited physical, sensory or mental abilities or with a
lack of experience and / or knowledge, unless they are supervised by a person responsible for their safety or if they have
received instructions on the use of the device. Children should be supervised to ensure that they do not play with the device.
Keep remote controls away from such persons.
A device mark (nameplate with name and address of the manufacturer, serial number, model number, supply voltage and
temperature range) must be applied by the user.
The example of the warning label must be attached to the motor near the motor terminal board.
Type label (example):
Warning notice label (example):
The safety advisories mentioned in this document make no claim to completeness. If you have questions about the
product, contact your vendor.
The manufacturer has carefully checked and inspected the hardware and software, but no warranty is given for a
complete absence of errors.
Dispose of the product at the end of its life cycle in accordance with the applicable
statutory provisions.
