Xl-4, XL-4B, and XL-5 Hookup and Installation Instructions
Version 4
5–8
UNBYPASS Zne 002
UPSTAIRS BEDROOM
Note: Bypassing can be performed either while the system is armed or disarmed.
A bypass signal will be transmitted to the Central Station if a bypass code has been
programmed and the zone has been enabled for bypass. If the system is disarmed an option
(auto unbypass enable) exists to retain the bypassed zones until a manual unbypass is
performed.
To immediately ARM the system enter [USER] after the last zone bypass.
On LED keypads the zone indicator LED for that zone will blink slowly.
If a zone is already bypassed, the bypass command will unbypass the zone.
Bypassed zones will not be protected when the system is armed.
Forced Arming
Forced Arming is a method that will automatically bypass all faulted zones and ARM the
system.
Forced Arming Procedure
BYPASS [USER] BYPASS
If any of the zones currently faulted are not bypassable, then the command will not succeed,
and a long beep will follow. A programming option exists to determine whether forced arming
is permitted.
Following a successful FORCED ARMING the ARMED indicator will be lit and the ARMING
(ON:AWAY) message will appear on the LCD display. Note: Forced arming capability can be
enabled or disabled through the programming sequence. User must be a level 1,2,3 or 4.
If the auto unbypass option is enabled and an alarm occurs during the armed period upon
disarm, bypassed zones will be retained until a second reset is performed.
UL
For UL applications this feature MUST not be enabled.
Unbypass
The UNBYPASS function removes an existing bypass from a currently bypassed zone.
The procedure is similar to a bypass.
Unbypass Procedure
BYPASS [USER] ZN
See bypass description.
UL
For UL systems bypassed zones should automatically be unbypassed during disarm (see
auto-unbypass option in programming guide).
