2 Loosen the captive screw at each end of the blank front panel, using a #2 Phillips screwdriver (
see
the following figure
).
Figure 71: Captive Screw on a BlackDiamond 8000 Series Blank Front Panel
3 Remove the blank front panel from the front of the BlackDiamond switch (
see the following figure
).
Figure 72: Removing a Blank Front Panel from a BlackDiamond 8800 Series Switch
4 Install an I/O module or MSM in the open slot as described in
Installing a BlackDiamond 8000 Series
Module
on page 90.
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is
always available when you need to handle ESD-sensitive components.
Installing a Compact Flash Memory Card
You do not need to power off the system or remove the MSM from the chassis to install a compact flash
memory card.
You need an ESD-preventive wrist strap to install a compact flash memory card.
Installing Modules and Establishing Initial Management Access
BlackDiamond 8800 Hardware Install Guide
99
