information about the module (name, serial number, part number), the state of the module (power
down, operational, mismatch between the slot configuration and the module in the slot), and the
number of ports on the module.
For more information about slot status information, see the
ExtremeXOS User Guide
and the
ExtremeXOS Command Reference Guide
.
Removing a BlackDiamond 8000 Series Module
Caution
BlackDiamond 8800, and 8900 Series modules have two styles of ejector/injector levers. Pay
careful attention to the instructions in step
2
on page 96.
This section describes how to remove modules from a BlackDiamond 8800 Series switch.
BlackDiamond modules are hot-swappable. You do not need to power the system off to remove a
module.
You need the following tools and equipment to remove a BlackDiamond 8500,8800, or 8900 Series
module:
•
ESD-preventive wrist strap
•
#2 Phillips screwdriver
•
Replacement module or blank front panel if you are not replacing the module
To remove a BlackDiamond module:
1 Attach the ESD-preventive wrist strap to your bare wrist. If it is not already connected, connect the
metal end to the ground receptacle at the top left corner of the chassis.
Installing Modules and Establishing Initial Management Access
BlackDiamond 8800 Hardware Install Guide
95
