Exabyte EZ17A, Инструкция по установке и эксплуатации, Страница: 101 / 168

Tape Drive Operation
Installation and Operation 85
M onitoring the drive LEDs
➤
Important
You must park the robot and
remove the cartridge magazine as described on
page 48 before you can view the drive’s LEDs.
The drive faceplate has three LEDs for indicating the drive’s
operational status.
The following tables show the most frequent LED states and the
conditions they indicate. You may see other LED activity (random
flashing, steady on, and so forth). For a detailed description of the
LEDs, refer to the installation and operation manual for your
drive.
M 2, M ammoth, and M ammoth-LT LEDs
LED states Condition
All LEDs on The drive was reset or it is performing its
pow er-on self-test.
Top LED on The drive requires cleaning or a cleaning
is in progress.
a
a
For M2 only, manual cleaning is required w hen standard AME media has been used.
Cleaning is automatic w hen AME w ith SmartClean cartridges are used exclusively.
Top LED flashing Hardware error or the drive failed POST.
Middle LED on A tape is loaded and the drive is ready to
perform tape motion activities.
Bottom LED flashing Tape motion. A fast flash indicates
high-speed tape motion.