Exabyte EZ17A, Инструкция по установке и эксплуатации, Страница: 159 / 168

Error Codes
Installation and Operation 143
211
Eject sensor error. There is a bad
sensor or the autoloader cannot
communicate w ith the tape drive
over the serial interface and there
is a cartridge protruding from the
tape drive.
§
Make sure the autoloader is not being
used by any host, then reset the
autoloader and the tape drive by
pow ering the autoloader off, wait 10
seconds, then powering it on again to
reset the tape drive.
CAUTION: Wait at least 10 seconds
between pow ering the autoloader off and
turning it back on again to allow the tape
drive sufficient time to complete its reset
operation.
§
If the error persists, contact your
service provider.
212
Remove tape in robot. A
cartridge w as in the robot during
POST.
§
Remove the magazine (it is unlocked).
§
Remove the cartridge from the robot
and place it in the magazine (if you
know where it goes).
§
Replace the magazine. The autoloader
automatically resumes post.
Error
no.
Description Corrective action