Exabyte EZ17A, Инструкция по установке и эксплуатации, Страница: 49 / 168

Configuration
Installation and Operation 33
Configuring the autoloader
This section describes how to set the autoloader’s configuration
options. Refer to the table below for an explanation of each
configuration item and determine which ones you need to set.
Then, follow the appropriate steps in this section to set those
options.
Configuration
option Description See...
SCSI M enu:
SCSI IDs Setting SCSI IDs is required for autoloader operation.
View the default settings and change them if
necessary. Page 34
Emulation Mode Setting an emulation mode is required if your
application softw are does not support an Exabyte
EZ17, but does support an Exabyte 210 library. Page 36
Robot M enu:
Robot Control Setting the robot control option determines which
interface is used to control the motion of the robot.
The control mode options are SCSI, Sequential, LCD,
and Console. Page 38
Sequential
Options Provides options for using the autoloader’s Sequential
mode. (See
page 53 for more information and
instructions for setting the Sequential mode options.)
Page 38
Serial Allow s you to set the baud rate for the autoloader’s
serial port or choose to communicate w ith the drive
over the serial port (see
page 102 ).
Page 91
Security M enu:
Security Setting security allows you to prevent unauthorized
personnel from disrupting the operation of the
autoloader. Page 40