Exabyte EZ17A, Инструкция по установке и эксплуатации, Страница: 51 / 168

Configuration
Installation and Operation 35
3. Press
[ENTER]
. The following screen appears:
4. If you want to change the current settings, press
[ENTER]
. The
message
Set SCSI IDs
flashes on the screen, then the
following screen appears:
5.
To change the drive’s SCSI ID, press 3 or 4 until you see the
ID you want. Or, if you only want to change the autoloader’s
SCSI ID, press
2 . The screen arrow moves to the far right digit
in the autoloader’s SCSI ID.
Note:
Certain software applications require the autoloader
SCSI ID to be set one digit lower than the drive SCSI
ID. Refer to the documentation for your software
application for more information.
6.
Press 3 or 4 until you see the SCSI ID you want for the
autoloader.
7.
Press [ENTER] .
8.
If you changed the SCSI ID for the drive, the following
message flashes on the screen:
Power cycle the autoloader to change the drive
SCSI ID or press ESCAPE to cancel
4
S C S I I D
D 0 1 A 0 0
D 0 1 A 0 0
↕
→