Exabyte EZ17A, Инструкция по установке и эксплуатации, Страница: 64 / 168

Chapter 4
48 Exabyte EZ17M and EZ17A
Removing and replacing the magazine
This section describes removing and replacing the magazine to
access the cartridges and the drive.
Removing the magazine
To remove the magazine to access the cartridges or the drive,
follow these steps:
1.
Release the magazine by pressing [REMOVE{{{{{MAG] and follow the
instructions on the screen. When the autoloader finishes the
current operation, it parks the robot in front of the drive and
releases the magazine’s solenoid.
Note:
Pressing [REMOVE{{{{{MAG] parks the robot in front of the
drive. If you want to access the drive, use the Park &
Unlock command from the Main Menu.
2.
Grasp the magazine at the top (near cartridge slot 7) and pull
out, as shown in the following figure.
CAUTION
Do not force the magazine out of the autoloader.
Doing so may damage the magazine or the
robot.