Evoqua W3T350215, Инструкция по эксплуатации

Страница: 20 / 60

20
4. Installation DEPOLOX® 5 E flow cell
EN
1 Installation of the module (chapter 4.5).
2 Remove the housing cover of the flow cell
(chapter 4.6).
3 Install the optional strainer (chapter 4.7).
4 Connect the sample water inlet (chapter 4.8)
• with tubing connection
• with rigid pipework
5 Connect the sample water outlet (chapter
4.9).
6 Installing the fine filter (chapter 4.11).
Only when using the membrane sensor.
7 Removing the felt ring (chapter 4.12).
8 Removing and replacing transport caps
(chapter 4.13).
9 Insert electrode cleaning sand (chapter
4.14).
10 Connecting the three-electrode measuring
cell and connecting sensors with DFMe
electronics module (chapter 4.15).
11 Fitting the sensors (chapter 4.16).
12 Fit calibration aids (chapter 4.17).
13 Refit the housing cover (chapter 4.6).
4.5 Installation of the module
Install the electronics module and flow cell
with or without DIN rail. Dimension drawing
chapter 4.5.3.
4.5.1 With DIN rail
1 Secure the DIN rail to a solid wall using
the dowels and screws supplied.
2 Hook the electronics module onto the DIN
rail so that it is flush at the right.
3 Fasten the electronics module to the solid
wall at the bottom by the holders using
dowels and screws.
4 Hook the flow cell on the DIN rail to the
left of the electronics module.
5 Fasten the flow cell to the solid wall at the
bottom by the holders using dowels and
screws.
4.5.2 Without DIN rail
The dimensions for the drilling pattern can be
found on the back of the plastic housing.
1 Attach the tallow-drop screws and dowels
provided to the solid wall (included in the
scope of delivery).
2 Hook the electronics module onto the
screws.
3 Fasten the electronics module to the solid
wall at the bottom by the holders using
dowels and screws.
4 Hook the flow cell onto the screws.
5 Fasten the flow cell to the solid wall at the
bottom by the holders using dowels and
screws.