32
4. Installation
DEPOLOX® 5 E flow cell
EN
A 3-electrode measuring cell (already
installed)
B
Membrane sensor for total chlorine TC3
CAN
C
Conductivity sensor
D Redox combined measuring and reference
electrode
E
LED glow stick
F
pH combined measuring and reference
electrode
4.17 Installing calibration aids
Two calibration clips are installed in the hou-
sing cover. These are inserted on the side at
the back of the main housing. The clips with
plastic inserts for sensor is pushed into the
upper catch (A). The second holding bracket
holds the calibration solution in a bag or cup.
For the solution in the bag, position the hol-
ding bracket in the upper position of the lower
holding device (B). For the cup, use the lower
position (C).
Fig. 14 Rear of flow cell
A Upper holding device
B
Position of holding device for bag
C
Position of holding device for cup
4.18 Commissioning
After the 700 P electronics module or 700 M
electronics module and DEPOLOX® 5 E flow
cell and sensors are installed, you can perform
the initial startup. For the procedure, see inst-
ruction manual “700 P electronics module” or
“700 M electronics module” and the corre-
sponding instructions for the sensors.
Non-pressurized
version
Pressurized version
Pressurized version with cell body
cover W3T417351(optional)
A
B
D
E
F
C
B C
F
E
D
A
B
D
E
F
C
A
B
C
DANGER
Risk of injury or death!
The DEPOLOX® 5 E flow cell must not be
used with flammable liquids.
NOTICE
Startup is described in the instruction
manuel "700 P Electronics module“ or inst-
ruction manuel "700 M Electronics module“.