Evinrude 30 HORSEPOWER MFE, Руководство оператора

Страница: 41 / 60

39

S
ERVICE
5) Spray the entire contents of a can of En-
gine Tuner , P/N 777185, into the throttle
body. Do not let the engine stall until the
can is empty.
6) STOP engine and allow Engine Tuner to
soak in powerhead for a minimum of 8
hours to 16 hours maximum.
DO NOT allow Engine Tuner to
stay in powerhead for more than 16 hours.
Extended exposure can damage internal
engine parts.
7) Restart engine and run at 1500 RPM for 15
minutes.
8) Next, run outboard on boat, at high speed,
for 30 to 60 minutes. Boat should be on
plane and outboard should be running at
least 2500 RPM.
If outboard will not run at high RPM, make
sure that spark plugs are not fouled. Replace
spark plugs if necessary. Refer to Spark
Plugs on p. 40.
FLUSHING
Flush the outboard with fresh water following
use in brackish, salt or polluted water to mini-
mize the accumulation of scale and silt depos-
its in cooling system passages. The outboard
can be flushed on the trailer or at dockside.
Place outboard in vertical (down) position in a
well ventilated area.
If you cannot store the out-
board in the recommended vertical posi-
tion, be sure the cooling system is
drained completely. Never place the
gearcase higher than the powerhead. Any
water remaining in the exhaust passages
can run into the cylinders and cause seri-
ous damage.
Using Lower Engine Cover Flushing
Port
1) Place the outboard in an area with good
drainage.
2) Connect garden hose to flushing port.
3) Turn on the water. It is not necessary to
run the engine for a good flushing.
4) Leave the outboard in vertical position long
enough to completely drain the power-
head.
Using Gearcase Flushing Device
1) Place the outboard in an area with good
drainage.
2) Temporarily cover the two small auxiliary
water inlet holes on each side of the
gearcase with heavy tape to insure enough
water travels to the powerhead from the
water intakes. Water can drain from auxil-
iary inlets, resulting in engine overheat Re-
member to uncover the holes after flushing
the engine.
NOTICE
NOTICE
002024
1. Auxiliary water inlet holes
2. Water intakes 007035
2
1