Estate Swing 433 Plug
-
in Receiver
1.
With the red plug already inside the control box, run the
grey receiver wire out of the box through one of the
water tight connections. DO NOT PERFORM THIS
STEP WITH THE RED PLUG ATTACHED TO THE
CONTROL BOARD.
2.
Find a location for the receiver box on the gate post or a
fence post that is within the length of the receiver wire.
3.
Using a #6 screw attached the top of the receiver to the
post. If you are happy with this position use the small
provided set screw in the bottom hole to secure the
receiver in place.
4.
Attach the receiver wire to the terminals as seen below.
Please note that you will find a factory installed jumper
wire connected on the receiver. Leave this jumper wire
in place. One of the terminals that has the jumper wire
will have the
2nd from the bottom
added to the terminal.
5.3
3rd from the
bottom = CH1
left
1st from the
bottom = V+
2nd from the
bottom = CH1
right (shaped
with jumper)
Содержание E-S 500
