5.4
Estate Swing 433 Plug
-
in Receiver (cont.)
5.
Plug the red clip inside the control box into the
control board. The groove in the red clips should
snap into the guide on the 5 prong connector.
6.
The red power light should come on the
receiver.
7.
Program your remotes to the receiver:
A.
Press and release the LEARN1 button at the
top of the receiver board (ex 1). The learn LED
will illuminate steady (ex 2). (
Fig
1
)
B.
Press and hold the button on the remote you
wish to program to the receiver.
C.
Hold the remote button until the Learn LED
flashes and then turns off. (caution your gate
opener may be triggered during this process)
D.
Repeat A through C for all additional remotes.
Fig.
1
NOTES ABOUT REMOTES:
You can program up to 400 codes into the receiver. This could mean 1 button on 400
different remotes or this could mean all 4 buttons on 100 remotes or anything in between.
Some choose to program all 4 buttons to a single receiver if they are not using multiple
gates to eliminate pressing the incorrect button on the remote. To do so follow the pro-
gramming above with each button of the remote. You can erase all programmed codes
by holding Learn 1 until the Learn LED comes ON and then turns OFF.
8.
Put the cover on the receiver and secure it in place
using
the provided screw.
IMPORTANT:
The receiver is a drip proof receiver. This means that it is
designed to prevent water from accessing the inside of the receiver when the water
is moving downward with gravity (rain for example).
DO NOT
mount the receiver anyplace that water may access it from another
angle. For example: Do not mount near sprinklers. Do not mount the receiver
horizontally. Do not mount the receiver near a flat surface where water could
splash upwards.
Содержание E-S 500
