E-S 500 / 502 Classic Series Instruction Manual
5.9
Accessories Wiring
The manufacturer instructions that come with your accessory should have markings for wires or
terminals to connect to the gate opener. Please look for terminals named below in the instruc-
tions for the accessory.
Keypads, Receivers:
Normally Open (NO) or Input (INP) or Relay of entry device
= COM terminal (to right of PUSH1) of
PUSH block on gate opener control board.
Common (COM) or Ground (GND) or Relay of entry device
= PUSH1 terminal of PUSH block on
gate opener control board.
NOTE:
If the power for the accessory shares a Ground wire/terminal with the relay – Do Not pow-
er that accessory off this control board (example: WKP-P keypad). Instead power that device
with batteries.
24V Power positive (+) or (24V) or (PWR) of entry device
= +24V terminal of PHOTO block on
gate opener control board.
24V Power Negative (-) or (GND) or (PWR) of entry device
= GND terminal of PHOTO block on
gate opener control board.
Push Button, Intercoms:
Normally Open (NO) or Input (INP) or Relay of entry device
= COM terminal (to right of PUSH1) of
PUSH block on gate opener control board.
Common (COM) or Ground (GND) or Relay of entry device
= PUSH1 terminal of PUSH block on
gate opener control board.
Push buttons do not require power and Intercoms draw too much power to power from the
gate opener.
Exit Wand/Sensor, Exit Loop Detector, Exit Device:
Normally Open (NO) or Input (INP) or Relay of exit device
= COM terminal (to right of PUSH2) of
PUSH block on gate opener control board.
Common (COM) or Ground (GND) or Relay of exit device
= PUSH2 terminal of PUSH block on
gate opener control board.
24V Power positive (+) or (24V) or (PWR) of exit device
= +24V terminal of PHOTO block on gate
opener control board.
24V Power Negative (-) or (GND) or (PWR) or Shield wire of exit device
= GND terminal of PHOTO
block on gate opener control board.
Содержание E-S 500
