Ericsson R380, Руководство пользователя, Страница: 22 / 262

22 Preparing for Use
Standby Mode
After you have turned on the R380 (and entered your PIN), the
R380 searches for a network.
When a network is found, the R380 beeps three times, Status
indicator light on top of the R380 flashes green once every
second, and your network operator’s name (in most cases
abbreviated) appears.
Note: See “Troubleshooting” on page 227 if you do not reach
standby mode.
When in the ‘Standby mode’ you can make and receive calls, use
the Phone book to make a call, view e-mail and SMS messages,
view the current day’s events, appointments and to-dos and
activate/deactivate a limited number of settings.
Other Modes
If the name of a network does not display it may be due to one of
the following reasons:
Emergency calls only
If ‘
Emergency calls only
’ displays, you are within coverage of a
network but you are not allowed to use that network. However,
in an emergency, you can call the international emergency
number used in that country . Furthermore, the light Status
indicator on top of the R380 does not flash.
Note: This service is network dependent, not all networks allow
you to make an emergency call.
No network
If ‘
No network
’ displays, there is no network coverage within
range, or the received signal is too weak, in which case you will
have to move to obtain a sufficiently strong signal. Notice that
the network strength indicator, at the bottom to the left of the
display, becomes a dashed line. Furthermore the light Status
indicator on top of the R380 does not flash.
Flip Closed Display
NETWORK
18-05-2000
12:00
Emergency
calls only
12:00
No network
18-05-2000
12:00