Quadro4Li Manual II: Administrator's Guide
Administrator’s Menus
Quadro4Li; (SW Version 5.3.x)
102
VoIP Carrier Wizard – Page 2
is used to define VoIP Carrier
Settings. The page contains following components:
1. VoIP Carrier Common Settings
The
Account Name
text field requires a username for
authentication on the defined SIP server.
The
Password
text field requires a password for authentication
on the defined SIP server.
The
Confirm Password
text field requires a password
confirmation. If the input is not corresponding to the one in the
Extension Password
field, the error message “Incorrect
Password confirm” will appear.
The
SIP Server
text field requires an IP address or the
hostname of the SIP server destination party it is registered on.
The
SIP Server Port
text field requires the port number of the
SIP server destination party it is registered on.
Fig. II-172: VoIP Carrier W izard page 2
2. VoIP Carrier Advanced Settings
The
Use RTP Proxy
checkbox is applicable only when a route is used for calls towards a configured VoIP Carrier from a peer located outside the
Quadro. When this checkbox is selected, the RTP streams between external users will be routed through Quadro. When the checkbox is not
selected, RTP packets will move directly between peers.
UserID
requires an identification parameter to reach the SIP server. It should have been provided by the SIP service provider and can be requested
only for certain SIP servers. For others, the field should be left empty.
Send Keep-alive Messages to Proxy
enables the SIP registration server accessibility to the verification mechanism.
Timeout
indicates the timeout
between two attempts of SIP registration server accessibility verification. If a reply is not received from the primary SIP server within this timeout, the
secondary SIP server will be contacted. When the primary SIP server recovers, SIP packets will continue to be sent to the server.
A group of
Host address
and
Port
text fields respectively require the host address (IP address or the host name), the port number of the
Outbound
Proxy
,
Secondary SIP Server
and the
Outbound Proxy for the Secondary SIP Server
. These settings are provided by the SIP servers’ providers
and are used by Quadro to reach the selected SIP servers.
VoIP Carrier Wizard – Page 3
contains the following VoIP
Carrier access code selection components:
The
Access code
text field requires a digit combination by
dialing which the corresponding VoIP Carrier will be reached.
The
Access code
radio buttons allows you to create outbound
routing rules.
•
By prefix
text field requires entering the prefix that will be
placed in front of the routing pattern instead of the
discarded digits. The Prefix field can consist of numeric
values only. A corresponding warning appears if any other
symbols are inserted.
•
By pattern
text field specifies calls to which the rule
should be applied. If an outbound call has a destination
number that matches the specified pattern, it will be
completed according to the current rule. A routing pattern
may contain wildcards. The complete list of characters and
wildcards allowed in this text field is given on the
page.
The
Route Incoming Calls to
drop down list allows you to select
an extension (or Auto Attendant) on the Quadro where incoming
calls from the configured VoIP Carrier should be routed to. For
the selected extension there will be an unconditional forwarding
set up which will care for incoming calls forwarding from the VoIP
carrier to the corresponding extension.
Fig. II-173: VoIP Carrier W izard page 3
The
Emergency Code
text field requires the emergency code supported by the specified ITSP. By default this field is filled with the information
, but this field also allows to define an ITSP specific emergency codes. In case your system has
