Quadro4Li Manual II: Administrator's Guide
Administrator’s Menus
Quadro4Li; (SW Version 5.3.x)
79
Inactive
– this selection disables the corresponding IP line.
SIP Phone
– this selection configures the IP line for a SIP phone to be
connected to the Quadro’s LAN.
•
Phone Model
drop down list is used to select the IP phone
model to be used by the receptionist. The drop down list,
excluding
Other
selection, enables the MAC address text
fields used to insert the
MAC Address
of the corresponding
SIP phone. Use
Other
selection if your SIP phone is not in
this list.
•
Line Appearance
text field requires a number of
simultaneous calls supported by the SIP phone.
•
Username
and
Password
are required for this selection.
They should match on both the Quadro and the SIP phone for
a successful connection. The
Password
field is checked
against its strength and you may see how strong is your
inserted password right below that field. To achieve the well
protected strong password minimum 8 characters of letters in
upper and lower case, symbols and numbers should be used.
If you are unable to define a strong password, press
Choose
Generated Password
to use one of system defined strong
passwords.
•
Transport
drop down list is used to select the SIP protocol
transport layer - UDP, TCP or TLS. For TLS you may activate
the TLS certificate update mechanism from IP Phone to
obtain the latest certificate generated by the Quadro.
For automatic SIP phone configuration, the SIP phone should be
reset/rebooted. The appropriate configuration will then be automatically
downloaded from Quadro to the SIP Phone.
Please Note:
For automatic configuration, some SIP phones may
require additional actions to follow the restart. For example, by default
the IP Dialog SIP Tone II is in a non-auto-provisioning mode, so it
should be manually enabled on the phone. Refer to the user’s manual
of the corresponding SIP phone for instructions on performing a factory
reset or reboot on any of the supported phones, what additional
configurations are required for a specific SIP phone, and how to
manipulate with the GUI.
By pressing the
Web
link in the
Details
column for each configured SIP
phone will lead you to the Web configuration page of the corresponding
SIP phone.
Please Note:
This link only works from the LAN side of the Quadro, i.e.
when the Quadro’s GUI is accessed from a PC located in the Quadro’s
LAN. If you wish to connect the SIP phone’s GUI through the WAN, an
appropriate
Incoming Traffic/Port Forwarding
be added on the Quadro.
The
Advanced
link in the
Details
column appears for the snom and
Aastra IP phones and takes you to the
page where programmable keys for the corresponding IP
phone can be configured.
The
Reboot
link in the
Details
column appears for supported IP phones
and is used to remotely initiate a reboot of an IP phone attached to the
line.
Fig. II-140: IP Line Settings page
Fig. II-141: IP Line Edit page
