Epson C204001 - DFX 8500 B/W Dot-matrix Printer, Руководство пользователя

Страница: 110 / 252

Auto I/F (interface) wait time
When the printer is in the auto interface mode and it receives
no data from the currently selected interface for the amount of
time specified with this setting, it determines which interface is
receiving data and switches to that interface. You can specify
10 seconds when DIP switch 4-2 is off. To specify 30 seconds,
turn DIP switch 4-2 on.
I/F (interface) mode
You may need to change DIP switches 4-3 and 4-4 so that your
printer and computer can communicate properly. These DIP
switches control the interface mode. (You may also need to
select a different serial baud rate. See the section below on
serial baud rate.)
Table D (page 4-16) lists the DIP switch settings for automatic,
parallel, serial, and optional interface modes. When you select
Auto, the printer automatically selects the interface that is
receiving data, and uses that interface until the end of the print
job. This setting allows you to share the printer among multiple
computers without changing the interface mode.
Serial parity
If your computer is set up for serial communication, you need
to change DIP switchs 4-5 and 4-6 so that your printer and
computer can communicate properly. These DIP switches
control the serial interface parity.
Table E (page 4-16) lists the DIP switch settings for none, odd,
even, and ignore parity.
L
Peony Rev.C
A5 size Chapter 4
98/01/07 Pass 4
4-20 Using the Printer